The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the front seat outer belt assembly removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch is turned off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>REMOVAL
for 1KR-FE:
Click hereGeneral>MAINTENANCE>1KR-FE AUXILIARY BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If an SRS part is accidentally deployed, it may cause a serious injury.
73350C
3.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Gasoline Model)
4.REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY (for Gasoline Model)
72693
5.REMOVE REAR SEAT CUSHION LOCK HOOK (for Gasoline Model)
76974F
6.REMOVE REAR UNDER SIDE COVER (for HV Model)
for LH Side:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL
for RH Side:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL
67917F
7.REMOVE REAR DOOR SCUFF PLATE INSIDE
62331A
8.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
Disconnect the rear door opening trim weatherstrip.
67913B
9.REMOVE FRONT DOOR SCUFF PLATE
62311B
10.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
Disconnect the front door opening trim weatherstrip.
73233
11.REMOVE LAP BELT OUTER ANCHOR COVER
|
Remove in this Direction |
Disengage the claws and guide to remove the lap belt outer anchor cover as shown in the illustration.
73210
12.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY
Remove the bolt to disconnect the floor anchor of the front seat outer belt assembly.
62413A
13.REMOVE CENTER PILLAR LOWER GARNISH
62411B
14.REMOVE CENTER PILLAR UPPER GARNISH
73210
15.REMOVE FRONT SEAT OUTER BELT ASSEMBLY
Remove the bolt to disconnect the shoulder anchor of the front seat outer belt assembly.
Using a screwdriver with its tip wrapped in protective tape, pull out the locking button to release the lock to disconnect the pretensioner connector as shown in the illustration.
| *A | for TMMF Made | *B | for TMC Made |
| *a | Protective Tape | *b | Locking Button |
Remove the 2 bolts.
Disengage the guides to remove the front seat outer belt assembly.