Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR (for 3 Door Front Door) › from 2020.09
RM36W0E _58 Vehicle Interior _088020 SUPPLEMENTAL RESTRAINT SYSTEMS _0452656 SIDE AIRBAG SENSOR(for 3 Door Front Door) A

SUPPLEMENTAL RESTRAINT SYSTEMS  SIDE AIRBAG SENSOR(for 3 Door Front Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 8983AA 1.INSTALL SIDE AIRBAG PRESSURE SENSOR

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
·

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




c.
B601713

Connect the airbag connector.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



d.
B601712

Engage the claw to hold the side airbag pressure sensor in place.


e.

Install the side airbag pressure sensor with the nut.

Torque:
7.8 N*m (80 kgf*cm, 69 in.*lbf)

NOTICE:
·

If the side airbag pressure sensor has been dropped, replace it with a new one.

·

When installing the side airbag pressure sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.




f.
B601714

Check that there is no looseness in the installation parts of the side airbag pressure sensor.


Hide 67832 2.INSTALL FRONT DOOR SERVICE HOLE COVER

Hide 68172A 3.INSTALL FRONT DOOR GLASS INNER WEATHERSTRIP

Hide 67602 4.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 67656 5.INSTALL FRONT DOOR TRIM GARNISH

Hide 74232 6.INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Driver Side)

Hide 74231 7.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)

Hide 67492A 8.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

Hide 9.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 10. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART