Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model TMMF Made) › 2020.07–2021.11
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0435240 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model TMMF Made) J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model TMMF Made)  Yaw Rate Sensor Wrong Installation (X0456)  


DESCRIPTION

Code Tester Display Measurement Item Trouble Area
X0456 Yaw Rate Sensor Wrong Installation History of yaw rate sensor (airbag ECU assembly) being installed incorrectly
·

Yaw rate and acceleration sensor (airbag sensor assembly) installed improperly

·

Yaw rate and acceleration sensor (airbag sensor assembly)



CAUTION / NOTICE / HINT

NOTICE:

After replacing or reinstalling the yaw rate and acceleration sensor (airbag sensor assembly), perform acceleration sensor zero point calibration and store system information memorization after performing "Reset Memory".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model TMMF Made)>UTILITY


PROCEDURE

1.CHECK FOR DTCs (HEALTH CHECK)
a.

Using the GTS, perform the Health Check.


Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

2.READ VALUE USING GTS

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

2.READ VALUE USING GTS
a.

Select the Data List using the GTS.

Chassis > Brake > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Yaw Rate Sensor Value Yaw rate sensor Min.: -128°/s, Max.: 127°/s Vehicle stopped: 0°/s
Turning right: -128 to 0°/s
Turning left: 0 to 127°/s
-
Chassis > Brake > Data List
Tester Display
Yaw Rate Sensor Value
50003 435 29

Result:
Result Proceed to
NG (The yaw rate sensor (airbag sensor assembly) output value is 0 deg/s when the vehicle is stationary, but the value fluctuates when turning.) A
NG (The yaw rate sensor (airbag sensor assembly) output value is not 0 deg/s when the vehicle is stationary.) B
OK C



A

3.CHECK AIRBAG SENSOR ASSEMBLY INSTALLATION

B

C

3.CHECK AIRBAG SENSOR ASSEMBLY INSTALLATION
a.

Check that the yaw rate and acceleration sensor (airbag sensor assembly) has been installed properly.

OK:

The sensor is tightened to the specified torque.

The sensor is not installed in a tilted position.



Result:
Proceed to
OK
NG



OK

4.CLEAR VEHICLE CONTROL HISTORY

NG

4.CLEAR VEHICLE CONTROL HISTORY
a.

Using the GTS, clear the Vehicle Control History.

Chassis > Brake > Utility
Tester Display
Vehicle Control History (RoB)
50005 435 55

Result:
Proceed to
NEXT



NEXT

5.PERFORM ZERO POINT CALIBRATION OF STEERING ANGLE SENSOR
5.PERFORM ZERO POINT CALIBRATION OF STEERING ANGLE SENSOR
a.

Drive the vehicle straight ahead at 35 km/h (22 mph) or more for at least 5 seconds.


Result:
Proceed to
NEXT



NEXT

END