Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type with TAS Type) › from 2021.04
RM36W0E _56 Audio / Visual / Telematics _088597 AUDIO / VIDEO _0475155 AUDIO AND VISUAL SYSTEM(for Radio and Display Type with TAS Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type with TAS Type)  Parking Brake Switch Circuit  


DESCRIPTION

This circuit is from the parking brake switch assembly to the radio and display receiver assembly.

WIRING DIAGRAM

E463252E01
4.885,2.115 6.583,2.667 1.698,0.552 10 false Radio and Display Receiver Assembly 4.885,1.938 5.375,2.375 0.49,0.438 10 false H80 2.656,1.448 3.146,1.885 0.49,0.438 10 false H37 2.656,1.646 4.021,2.177 1.365,0.531 10 false Parking Brake Switch Assembly 3.677,1.01 4.167,1.448 0.49,0.438 10 false 1 5.167,0.99 5.656,1.427 0.49,0.438 10 false 20 5.406,1.125 5.896,1.563 0.49,0.438 10 false PKB 3.5,1.01 3.677,1.26 0.177,0.25 10 false +

PROCEDURE

1.CHECK PARKING BRAKE SWITCH ASSEMBLY (OPERATION CHECK)
a.
E463241

Enter the "System Parameters" screen. Refer to system parameter list in System Parameter.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM (for Radio and Display Type with TAS Type)>DTC CHECK / CLEAR


b.

Check that the display changes between ON and OFF according to the parking brake operation.

OK
Parking Brake Condition Display
Applied ON
Released OFF

HINT:

This display is updated once per second. As a result, it is normal for the display to lag behind the actual parking brake operation.



Result:
Proceed to
OK
NG



OK

NG

2.INSPECT PARKING BRAKE SWITCH ASSEMBLY
2.INSPECT PARKING BRAKE SWITCH ASSEMBLY

Click hereBrake>PARKING BRAKE>PARKING BRAKE SWITCH>INSPECTION

Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - RADIO AND DISPLAY RECEIVER ASSEMBLY)

NG

REPLACE PARKING BRAKE SWITCH ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - RADIO AND DISPLAY RECEIVER ASSEMBLY)
a.

Disconnect the H80 radio and display receiver assembly connector.


b.

Disconnect the H37 parking brake switch assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H80-20 (PKB) - H37-1 (+) Always Below 1 Ω
H80-20 (PKB) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR