The combination meter assembly and radio and display receiver assembly communicate via local bus communication. This allows audio and visual system information to be displayed on the multi-information display.
This DTC is stored when a communication error occurs between the radio and display receiver assembly and combination meter assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B132187 | Lost Communication with EMV Missing Message | Diagnosis Condition:
·
The ignition switch is ON ·
IG power source voltage is 9.5 V or more Malfunction Status: No communication with radio and display receiver assembly Malfunction Time: 30 seconds or more |
·
Harness or connector ·
Radio and display receiver assembly ·
Combination meter assembly |
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Check vehicle condition.
| Result | Proceed to |
|---|---|
| w/ Navigation System | A |
| w/o Navigation System | B |
A
B
Check if navigation system DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Check if headup display system DTCs are output.
If DTC B132187 is output from the meter / gauge system and is not output from the headup display system, it can be suspected that the combination meter assembly has an internal malfunction.
If DTC B132187 is output from the headup display system and is not output from the navigation system, it can be suspected that the radio and display receiver assembly has an internal malfunction.
| Result | Proceed to |
|---|---|
| B132187 is not output | A |
| B132187 is output | B |
A
B
Check if audio and visual system DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Replace the combination meter assembly with a new one.
| Proceed to |
|---|
| NEXT |
NEXT
Pre-procedure1
Turn the ignition switch to ON.
Wait 30 seconds or more.
Procedure1
Check if meter / gauge system DTCs are output.
Post-procedure1
None
| Result | Proceed to |
|---|---|
| B132187 is not output | A |
| B132187 is output | B |
A
B