The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front stabilizer bar removal/installation are shown below.
1.REMOVE STEERING LINK ASSEMBLY
for G16E-GTS:
Click hereSuspension>FRONT SUSPENSION>FRONT SUSPENSION MEMBER (for G16E-GTS)>REMOVAL
except G16E-GTS:
Click hereSuspension>FRONT SUSPENSION>FRONT SUSPENSION MEMBER (except G16E-GTS)>REMOVAL
48810
2.REMOVE FRONT STABILIZER LINK ASSEMBLY LH
Remove the nut and front stabilizer link assembly LH from the front shock absorber assembly.
Do not damage the boot of the ball joint.
If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.
48820B
3.REMOVE FRONT STABILIZER LINK ASSEMBLY RH
Perform the same procedure as for the LH side.
48811
4.REMOVE FRONT STABILIZER BAR
Remove the 4 bolts and front stabilizer bar from the front suspension crossmember sub-assembly.