89342A
1.REMOVE REAR CENTER ULTRASONIC SENSOR (w/ Parking Support Brake System)
89342
2.REMOVE REAR CORNER ULTRASONIC SENSOR (w/ Parking Support Brake System)
89348S
3.REMOVE REAR CENTER ULTRASONIC SENSOR RETAINER (w/ Parking Support Brake System)
89348R
4.REMOVE REAR CORNER ULTRASONIC SENSOR RETAINER (w/ Parking Support Brake System)
5.REMOVE BACK-UP LIGHT ASSEMBLY
82182
6.REMOVE NO. 2 LUGGAGE ROOM WIRE
w/ Parking Support Brake System:
Disengage the clamps to remove the No. 2 luggage room wire.
w/o Parking Support Brake System:
Disengage the clamps to remove the No. 2 luggage room wire.
81920
7.REMOVE REFLEX REFLECTOR ASSEMBLY LH
Remove the screw.
Disengage the claw and guide to remove the reflex reflector assembly LH.
81910
8.REMOVE REFLEX REFLECTOR ASSEMBLY RH
Use the same procedure as for the LH side.
52453
9.REMOVE REAR BUMPER CENTER GUARD
Remove the 2 clips.
for TMC Made:
Disengage the claws to remove the rear bumper center guard.
for TMMF, TMMCZ Made:
Disengage the claws and guides to remove the rear bumper center guard.
52576
10.REMOVE REAR BUMPER SIDE RETAINER LH (for TMC Made)
w/ Blind Spot Monitor System:
Disengage the wire harness clamps.
Disengage the clips as shown in the illustration.
Disengage the claw and guide to remove the rear bumper side retainer LH.
52575
11.REMOVE REAR BUMPER SIDE RETAINER RH (for TMC Made)
Use the same procedure as for the LH side.
52576
12.REMOVE REAR BUMPER SIDE RETAINER LH (for TMMF, TMMCZ Made)
w/ Blind Spot Monitor System:
Disengage the wire harness clamps.
Remove the 2 screws.
Disengage the claw and guide to remove the rear bumper side retainer LH.
52575
13.REMOVE REAR BUMPER SIDE RETAINER RH (for TMMF, TMMCZ Made)
Use the same procedure as for the LH side.
14.REMOVE REAR COMBINATION LIGHT ASSEMBLY LH
for Halogen Headlight:
Click hereVehicle Exterior>LIGHTING (EXT)>REAR COMBINATION LIGHT ASSEMBLY (for Halogen Headlight)>REMOVAL
for LED Headlight:
Click hereVehicle Exterior>LIGHTING (EXT)>REAR COMBINATION LIGHT ASSEMBLY (for LED Headlight)>REMOVAL
15.REMOVE REAR COMBINATION LIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
52156A
16.REMOVE REAR BUMPER SIDE SUPPORT LH
w/ Blind Spot Monitor System:
Disengage the wire harness clamp.
Remove the screw and rear bumper side support LH.
52155A
17.REMOVE REAR BUMPER SIDE SUPPORT RH
Use the same procedure as for the LH side.
52023
18.REMOVE REAR BUMPER REINFORCEMENT SUB-ASSEMBLY (w/ Reinforcement)
Remove the 6 bolts and rear bumper reinforcement sub-assembly.