The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the engine room fusible link removal/installation are shown below.
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
89661
2.REMOVE ECM
82662A
3.REMOVE NO. 1 RELAY BLOCK COVER
28371
4.REMOVE NO. 1 IGNITION RELAY
Remove the No. 1 ignition relay.
85948
5.REMOVE WINDSHIELD WIPER RELAY
Remove the windshield wiper relay.
85912K
6.REMOVE VVT RELAY
Remove the VVT relay.
89730A
7.REMOVE SECURITY WARNING RELAY
Remove the security warning relay.
82663
8.REMOVE RELAY BLOCK LOWER COVER
Remove the nut.
Disconnect the 2 connectors.
| *a | Protective Tape |
|
Separate in this Direction |
Using a screwdriver with its tip wrapped in protective tape, disengage the claws to separate the wire harness as shown in the illustration.
for RHD:
Disengage the clamps to separate the wire harness.
Remove the 2 bolts and nut.
| *1 | Engine Room Relay Block Assembly |
Disengage the guides to separate the engine room relay block assembly.
Disengage the clamp to separate the wire harness.
|
Protective Tape |
Apply protective tape to the engine room relay block as shown in the illustration.
Remove the wire harness repair tapes.
Disengage the claws to separate the relay block lower cover.
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, disengage the claws to separate the wire harness.
Remove the relay block lower cover.
82610A
9.SEPARATE FUSE BLOCK ASSEMBLY
| *a | Protective Tape |
|
Separate in this Direction |
Using a screwdriver with its tip wrapped in protective tape, disengage the claws to separate the wire harness as shown in the illustration.
Remove the vinyl tape.
|
Move in this Direction |
Move the engine room relay block as shown in the illustration.
| *a | Protective Tape |
|
Separate in this Direction |
Using a screwdriver with its tip wrapped in protective tape, disengage the claws to separate the fuse block assembly as shown in the illustration.
82210P
10.REMOVE ENGINE ROOM FUSIBLE LINK
|
Remove in this Direction |
Remove the 2 bolts and engine room fusible link as shown in the illustration.