2005-2008 Yaris · Service Manual SECURITIES

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Nov 2006


CHECK DTC

  1. A107925E01
    Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG) and turn the intelligent tester ON.

  3. Select the following menu items: Body / Theft Deterrent ECU / DTC.

  4. Check DTCs and then write them down.

    HINT:
    Refer to the intelligent tester operator's manual for further details.

  5. Confirm the details of the DTCs.


CLEAR DTC (Using an intelligent tester)
  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG) (do not start the engine) and turn the intelligent tester ON.

  3. Select the following menu items: Body / Theft Deterrent ECU / DTC / Clear.

    HINT:
    Refer to the intelligent tester operator's manual for further details.

  4. Erase DTCs by pressing the YES button on the tester.

    HINT:
    If you need help when using the intelligent tester, refer to the instruction manual.


CLEAR DTC (Without using an intelligent tester)
  1. Remove the ECU-B fuse from the engine room R/B for more than 60 seconds, or disconnect the negative battery cable for more than 60 seconds. When disconnecting the negative battery cable, perform the "INITIALIZE" procedure.

← DIAGNOSIS SYSTEM (from Nov 2006)DATA LIST / ACTIVE TEST (from Nov 2006) →