2005-2008 Yaris · Service Manual SECURITIES

DIAGNOSIS SYSTEM

Troubleshooting · Vehicles built from Nov 2006


DESCRIPTION
  1. The theft warning ECU controls the functions of the theft deterrent system on the vehicle. Theft deterrent system data can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs.


CHECK DLC3
H100769E16
  1. The ECU uses ISO 15765-4 for communication. The terminal arrangement of the DLC3 complies with ISO 15031-3 and matches the ISO 15765-4 format.

    Symbols (Terminal No.)
    Terminal Description
    Condition
    Specified Condition
    SIL (7) - SG (5)
    Bus " +" line
    During transmission
    Pulse generation
    CG (4) - Body ground
    Chassis ground
    Always
    Below 1 Ω
    SG (5) - Body ground
    Signal ground
    Always
    Below 1 Ω
    BAT (16) - Body ground
    Battery positive
    Always
    10 to 14 V
    CANH (6) - CANL (14)
    CAN bus line
    Engine switch off*
    54 to 69 Ω
    CANH (6) - CG (4)
    HIGH-level CAN bus line
    Engine switch off*
    200 Ω or higher
    CANL (14) - CG (4)
    LOW-level CAN bus line
    Engine switch off*
    200 Ω or higher
    CANH (6) - BAT (16)
    HIGH-level CAN bus line
    Engine switch off*
    6 kΩ or higher
    CANL (14) - BAT (16)
    LOW-level CAN bus line
    Engine switch off*
    6 kΩ or higher

    NOTICE:
    *: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the engine switch, any other switches or the doors.

    If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.

  2. A107925E01
    Connect the cable of the intelligent tester to the DLC3, turn the engine switch on (IG) and attempt to use the intelligent tester. If the screen displays a communication error message, a problem exists in the vehicle or the tester.
    1. If communication is normal when the tool is connected to another vehicle, inspect the DLC3 on the original vehicle.
    2. If communication is still impossible when the tool is connected to another vehicle, the problem is probably in the tool itself. Consult the Service Department listed in the tool's instruction manual.


CHECK BATTERY VOLTAGE
If the voltage is below 11 V, replace the battery before proceeding.

Standard voltage:
11 to 14 V

← TERMINALS OF ECU (from Nov 2006)DTC CHECK / CLEAR (from Nov 2006) →