2005-2008 Yaris · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built from Aug 2005


INSPECT CLUTCH DISC ASSEMBLY

C062956
  1. Using vernier calipers, measure the rivet head depth.

    Minimum rivet depth:
    0.3 mm (0.012 in.)

    If necessary, replace the clutch disc.

  1. F100379E01
    Install the clutch disc onto the transaxle.

    NOTICE:
    Insert the clutch disc in the correct direction.

  1. Using a dial gauge, measure the clutch disc runout.

    Maximum runout:
    0.8 mm (0.031 in.)

    If necessary, replace the clutch disc.


INSPECT CLUTCH COVER ASSEMBLY

D029069E03
  1. Using vernier calipers, measure the depth and width of the diaphragm spring wear.

    Maximum:
    0.5 mm (0.020 in.) for part A (Depth)
    6.0 mm (0.236 in.) for part B (Width)

    If necessary, replace the clutch cover.


INSPECT FLYWHEEL SUB-ASSEMBLY

C062958
  1. Using a dial gauge, check the flywheel runout.

    Maximum runout:
    0.1 mm (0.004 in.)

    If necessary, replace the flywheel.


INSPECT CLUTCH RELEASE BEARING ASSEMBLY

Q001060
  1. Turn the release bearing in both directions by hand while applying force in the axial direction.

    HINT:
    The bearing is permanently lubricated and requires no cleaning or lubrication.
    If necessary, replace the release bearing.

← REMOVAL (from Aug 2005)INSTALLATION (from Aug 2005) →