REMOVAL
Removal / installation · Vehicles built from Aug 2005
| 1. REMOVE MANUAL TRANSAXLE ASSEMBLY |
| 2. REMOVE CLUTCH RELEASE BEARING ASSEMBLY |
![]() ![]() |
Remove the clutch release bearing from the clutch release fork.
| 3. REMOVE CLUTCH RELEASE FORK LEVER |
Using 2 screwdrivers and a hammer, tap the E-ring out.

Pull the clutch release fork lever out of the transaxle case to remove the clutch release fork from the transaxle case.

| 4. REMOVE CLUTCH RELEASE FORK LEVER SHAFT OIL SEAL |
![]() ![]() |
Using a screwdriver, remove the clutch release fork lever oil seal.
| 5. REMOVE CLUTCH HOUSING COVER NO. 1 |
![]() ![]() |
Remove the clutch housing cover from the transaxle case.
| 6. REMOVE CLUTCH COVER ASSEMBLY |
![]() ![]() |
Align the matchmark on the clutch cover with the one on the flywheel.
Loosen each set bolt by one turn at a time until the spring tension is released.
Remove the set bolts and the clutch cover.
- NOTICE:
- Do not drop the clutch disc.
| 7. REMOVE CLUTCH DISC ASSEMBLY |
- NOTICE:
- Keep the lining part of the clutch disk and the surfaces of the pressure plate and flywheel free of oil and foreign matter.




