2005-2008 Yaris · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Aug 2005


1. INSTALL CLUTCH DISC ASSEMBLY

F100378E01
  1. Insert SST into the clutch disc, and then insert them into the flywheel.

    SST
    09301-00210  

    NOTICE:
    Insert the clutch disc in the correct direction.


2. INSTALL CLUTCH COVER ASSEMBLY

D026323E02
  1. Align the matchmark on the clutch cover with the one on the flywheel.

  1. Tighten the 6 bolts uniformly in the order shown in the illustration, starting with the bolt located near the knock pin at the top.

    Torque:
    19 N*m{ 195 kgf*cm , 14 ft.*lbf }

    HINT:
    After checking that the disc is in the center, gently move SST up and down, right and left to tighten the bolts.

    SST
    09301-00210  


3. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY

C062961
  1. Using a dial indicator with a roller instrument, check the diaphragm spring tip alignment.

    Maximum non-alignment:
    0.8 mm (0.032 in.)

  1. D029849E02
    If the alignment is not as specified, using SST, adjust the diaphragm spring tip alignment.
    SST
    09333-00013  


4. INSTALL CLUTCH HOUSING COVER NO. 1

F100340
  1. Install clutch housing cover No. 1 onto the manual transaxle case.


5. INSTALL CLUTCH RELEASE FORK LEVER SHAFT OIL SEAL

F100377E01
  1. Using SST and a hammer, tap in a new select lever shaft oil seal until its surface is flush with the manual transaxle case.

    SST
    09950-60010   (09951-00290)
    09950-70010   (09951-07150)


6. INSTALL CLUTCH RELEASE FORK LEVER

  1. C118345
    Apply clutch release grease to the contact surface between the release bearing and the release fork, the rotating and sliding parts of the release lever and the spline coupling part.

    NOTICE:
    Apply grease uniformly to the rotating and sliding parts of the release lever and spline coupling part. Remove any grease extending beyond the release lever joining part.

  1. C118347
    Install the release fork lever onto the transaxle case together with the torsion spring, spring stopper and the release fork.

  1. F100370
    Using a screwdriver and hammer, install a new E-ring.


7. INSTALL CLUTCH RELEASE BEARING ASSEMBLY

C118346
  1. Install the release bearing onto the transaxle case.


8. INSTALL MANUAL TRANSAXLE ASSEMBLY
(Click here)
← INSPECTION (from Aug 2005)COMPONENTS (from Nov 2005) →