2005-2008 Yaris · Service Manual BRAKE

C0226/21 SFR Solenoid Circuit

Diagnostic trouble codes · Vehicles built from Aug 2005

Also covers:

DESCRIPTION

This solenoid is turned on in accordance with signals from the skid control ECU and controls the pressure on the wheel cylinders to control the braking force.
DTC No.
DTC Detecting Condition
Trouble Area
C0226/21
C0236/22
C0246/23
C0256/24
Open or short in solenoid circuit continues for 0.05 seconds or more.
ABS and TRACTION actuator
C1225/25
When any of following conditions detected:
  1. During switching solenoid (SM1 or SM2) ON signal input, overcurrent continues for 0.05 seconds or more.
  2. During switching solenoid (SM1 or SM2) OFF signal input, open circuit continues for 0.05 seconds or more.
  3. During switching solenoid (SM1 or SM2) ON signal input, open circuit continues for 0.01 second or more.
  4. During switching solenoid (SM1 or SM2) OFF signal input, current continues to be applied for 0.1 second or more.
  5. Short to GND in switching solenoid (SM1 or SM2) continues for 0.1 second or more.
  6. Switching solenoids SM1 and SM2 are shorted for 0.1 second or more.
ABS and TRACTION actuator

HINT:
C0226/21, C0236/22, C0246/23, C0256/24 and C1225/25:
The skid control ECU begins to detect these DTCs when the vehicle speed exceeds 6 km/h (4 mph).


WIRING DIAGRAM

C118705E01

INSPECTION PROCEDURE


1. RECONFIRM DTC
  1. Clear the DTC(s) (Click here).

  1. Start the engine.

  1. Drive the vehicle at 6 km/h (4 mph) or more to activate the initial check.

  1. Check if the same DTC(s) is output (Click here).

    Result
    Proceed to
    DTC output
    A
    DTC not output
    B

    HINT:
    The DTCs may be stored due to a malfunction in the connector terminal.



B
END
A

REPLACE ABS AND TRACTION ACTUATOR


← C0210/33 Right Rear Wheel Speed Sensor Signal (+ 7 more codes) (from Aug 2005)C0273/13 Open or Short Circuit in ABS Motor Relay Circuit (+ C0274/14, C1361/91) (from Aug 2005) →