2005-2008 Yaris · Service Manual BRAKE

C0226/21 SFR Solenoid Circuit

Diagnostic trouble codes · Vehicles built from Nov 2005

Also covers:

DESCRIPTION

This solenoid is turned on in accordance with signals from the skid control ECU and controls the pressure on the wheel cylinders to control the braking force.
DTC No.
DTC Detecting Condition
Trouble Area
C0226/21
C0236/22
C0246/23
C0256/24
Open or short in solenoid circuit continues for 0.05 seconds or more.
ABS and TRACTION actuator
C1225/25
C1226/26
C122727
C1228/28
When any of following conditions detected:
  1. During switching solenoid (SMC1, SMC2, SRC1 or SRC2) ON signal input, overcurrent continues for 0.05 seconds or more.
  2. During switching solenoid (SMC1, SMC2, SRC1 or SRC2) OFF signal input, open circuit continues for 0.05 seconds or more.
  3. During switching solenoid (SMC1, SMC2, SRC1 or SRC2) ON signal input, open circuit continues for 0.01 seconds or more.
  4. During switching solenoid (SMC1, SMC2, SRC1 or SRC2) OFF signal input, current continues to be applied for 0.1 seconds or more.
  5. Short to GND in switching solenoid (SMC1, SMC2, SRC1 or SRC2) continues for 0.1 seconds or more.
  6. Switching solenoids (SMC1, SMC2, SRC1 or SRC2) shorted for 0.1 seconds or more.
ABS and TRACTION actuator

WIRING DIAGRAM

C129376E01

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform zero point calibration (Click here).


1. RECONFIRM DTC
  1. Clear the DTC(s) (Click here).

  1. Start the engine.

  1. Check if the same DTC(s) is output (Click here).

    Result:
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B

    HINT:
    The DTCs may be stored due to a malfunction in the connector terminal.



B
END
A

REPLACE ABS AND TRACTION ACTUATOR


← C0210/33 Right Rear Wheel Speed Sensor Signal (+ 7 more codes) (from Nov 2005)C0278/11 Open or Short Circuit in ABS Solenoid Relay Circuit (from Nov 2005) →