2005-2008 Yaris · Service Manual BRAKE

C0278/11 Open or Short Circuit in ABS Solenoid Relay Circuit

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

The solenoid relay supplies power to the ABS solenoid and TRC solenoid.
After the ignition switch is turned on (IG), the vehicle speed has reached 20 km/h (12 mph) and the solenoid is determined to be normal by the initial check self-diagnosis, the relay switches on. If any open or short circuits are detected, the relay switches off.
This DTC may be set if the voltage supply to the solenoid relay (+BS) falls below the DTC detection threshold due to the battery or alternator outputs being insufficient.
DTC No.
DTC Detecting Conditions
Trouble Areas
C0278/11
When either of following conditions (1 or 2) detected:
  1. Malfunction in skid control ECU continues for 0.056 seconds or more.
  2. Voltage supply to solenoid valve stops for 0.056 seconds or more.
  1. ABS2/VSC2 fuse
  2. Wire harness (+BS)
  3. ABS and TRACTION actuator

WIRING DIAGRAM

C129340E02

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform zero point calibration (Click here).


1. INSPECT FUSE (ABS2/VSC2)

  1. C117851E04
    Remove the ABS2/VSC2 fuse from the engine room R/B.

  1. Measure the resistance.

    Standard Resistance:
    Below 1 Ω



NG
CHECK FOR SHORTS IN ALL HARNESSES AND CONNECTORS CONNECTED TO FUSE AND REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (BATTERY - SKID CONTROL ECU - BODY GROUND)

  1. C129347E02
    Disconnect the skid control ECU connector.

  1. Measure the voltage.

    Standard Voltage:
    Tester Connection
    Specified Condition
    A39-14 (+BS) - Body ground
    10 to 14 V

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    A39-13 (GND1) - Body ground
    Below 1 Ω
    A39-26 (GND2) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Start the engine.

  1. Check if the same DTCs are output (Click here).

    Result:
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE ABS AND TRACTION ACTUATOR


← C0226/21 SFR Solenoid Circuit (+ 7 more codes) (from Nov 2005)C0371/71 Yaw Rate Sensor (Test Mode DTC) (+ C1232/32, C1234/34, C1279/79) (from Nov 2005) →