2005-2008 Yaris · Service Manual BRAKE

ABS Warning Light does not Come ON

Circuit diagnosis · Vehicles built from Nov 2005

WIRING DIAGRAM

Click here.

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform zero point calibration (Click here).


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC not output
    A
    DTC output
    B



B
REPAIR CAN COMMUNICATION SYSTEM
A


2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (ABS WARNING LIGHT)

  1. A107926E08
    Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the tester on.

  1. Select the "ABS Warning Lamp" in the ACTIVE TEST and operate the ABS warning light using the intelligent tester.Select the following menu items: Chassis / ABS/VSC/TRC / Active Test.

    ACTIVE TEST: ABS/VSC/TRC 
    Item (Display)
    Test Details
    Diagnostic Notes
    ABS Warning Lamp
    Turns ABS warning light ON and OFF
    Observe combination meter

  1. Check that the ABS warning light turns on and off in the combination meter using the intelligent tester.

    OK:
    The ABS warning light turns ON and OFF in accordance with the intelligent tester operation.



NG
CHECK COMBINATION METER SYSTEM
OK

REPLACE ABS AND TRACTION ACTUATOR


← ABS Warning Light Remains ON (from Nov 2005)VSC Warning Light Remains ON (from Nov 2005) →