2005-2008 Yaris · Service Manual BRAKE

VSC Warning Light Remains ON

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

If the skid control ECU stores any DTCs which relate to the VSC system, the VSC warning light comes on in the combination meter.
The skid control ECU is connected to the combination meter via the CAN communication system.

WIRING DIAGRAM

C120365E02
C117853E03

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform the zero point calibration (Click here).


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC not output
    A
    DTC output
    B



B
REPAIR CAN COMMUNICATION SYSTEM
A


2. CHECK SKID CONTROL ECU CONNECTOR
  1. Check if the skid control ECU connector is securely connected.

    OK:
    The connector is securely connected.



NG
CONNECT CONNECTOR CORRECTLY
OK


3. INSPECT COMBINATION METER
  1. Check the combination meter assembly (Click here).



NG
REPLACE COMBINATION METER
OK

REPLACE ABS AND TRACTION ACTUATOR


← ABS Warning Light does not Come ON (from Nov 2005)VSC Warning Light does not Come ON (from Nov 2005) →