2005-2008 Yaris · Service Manual BRAKE

TC and CG Terminal Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the skid control ECU to display 2-digit DTCs by flashing the ABS warning light.

WIRING DIAGRAM

C118698E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (DLC3 - ECM)

  1. H102133E02
    Turn the ignition switch off.

  1. Disconnect the ECM connector.

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    D15-13 (TC) - A21-27 (TC)
    Below 1 Ω
    D15-13 (TC) - A32-7 (TC)
    Below 1 Ω
    D15-13 (TC) - A49-28 (TC)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)

  1. F100115E26
    Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    D15-4 (CG) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (ECM - BODY GROUND)

  1. H102134E02
    Disconnect the ECM connector.

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    A21-27 (TC) - Body ground
    10 kΩ or higher
    A32-7 (TC) - Body ground
    10 kΩ or higher
    A49-28 (TC) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. REPLACE ECM
  1. Replace the ECM.

  1. Check for DTCs of the ECM.

    Result:
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B

    HINT:
    1. 1KR-FE: (Click here)
    2. 1ND-TV: (Click here)
    3. 2SZ-FE: (Click here)



B
END
A

REPAIR CIRCUITS INDICATED BY OUTPUT DTCS


← Skid Control Buzzer Circuit (from Nov 2005)TS and CG Terminal Circuit (from Nov 2005) →