2005-2008 Yaris · Service Manual BRAKE

Skid Control Buzzer Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

The skid control buzzer sounds while the VSC is activated.

WIRING DIAGRAM

C122524E02

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform the zero point calibration (Click here).


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC not output
    A
    DTC output
    B



B
REPAIR CAN COMMUNICATION SYSTEM
A


2. PERFORM ACTIVE TEST BY INTELLIGENT TESTER (SKID CONTROL BUZZER)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the tester on.

  1. Select the ACTIVE TEST mode on the intelligent tester.

    ACTIVE TEST: ABS/VSC/TRC 
    Item (Display)
    Test Details
    Diagnostic Note
    Buzzer
    Turns skid control buzzer ON / OFF
    Buzzer can be heard

  1. Check that the buzzer sounds and stops sounding when the skid control buzzer is turned on and off using the intelligent tester.

    OK:
    The skid control buzzer sounds and stops sounding in accordance with the intelligent tester operation.



NG
Go to step 3
OK

REPLACE ABS AND TRACTION ACTUATOR

3. INSPECT COMBINATION METER
  1. Inspect the combination meter (Click here).



NG
REPLACE COMBINATION METER
OK

REPLACE ABS AND TRACTION ACTUATOR


← Slip Indicator Light does not Come ON (from Nov 2005)TC and CG Terminal Circuit (from Nov 2005) →