2005-2008 Yaris · Service Manual ENGINE

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Aug 2005


CHECK DTC

  1. A107926E01
    Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG) and turn the intelligent tester ON.

  3. Select the following menu items: Powertrain / Engine and ECT / DTC.

  4. Check DTCs and freeze frame data, and then write them down.

    HINT:
    If you need help using the intelligent tester, refer to the instruction manual.

  5. Confirm the details of the DTCs. (Click here)


FREEZE FRAME DATA
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG) and turn the intelligent tester ON.

  3. Read DTCs by selecting the following menu items: Powertrain / Engine and ECT / DTC.

  4. Select a parameter(s) to check the freeze frame data.

  5. Note down the DTC(s) and freeze frame data.

    HINT:
    If you need help using the intelligent tester, refer to the instruction manual.


CLEAR DTC AND FREEZE FRAME DATA (using the intelligent tester)
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG) (do not start the engine) and turn the intelligent tester ON.

  3. Select the following menu items: Powertrain / Engine and ECT / DTC / Clear.

  4. Erase DTCs and freeze frame data by pressing the YES button on the tester.

    HINT:
    If you need help using the intelligent tester, refer to the instruction manual.


CLEAR DTC AND FREEZE FRAME DATA (not using the intelligent tester)
  1. Remove the EFI fuse from the engine room R/B for more than 60 seconds, or disconnect the negative battery cable for more than 60 seconds.

← DIAGNOSIS SYSTEM (from Aug 2005)FAIL-SAFE CHART (from Aug 2005) →