TS and CG Terminal Circuit
Circuit diagnosis · Vehicles built from Aug 2005
DESCRIPTION
In sensor check mode, malfunctions of the speed sensor that cannot be detected when the vehicle is stopped can be detected by driving the vehicle.Transition to sensor check mode can be performed by connecting terminals TS and CG of the DLC3 and turning the ignition switch from off to on (IG).
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (DLC3 - POWER STEERING ECU) |
Turn the ignition switch off.
Disconnect the power steering ECU connector.
Measure the resistance.

- Standard Resistance:
Tester Connection
Specified Condition
D15-12 (TS) - D31-11 (TS)
Below 1 Ω
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND) |
Measure the resistance.

- Standard Resistance:
Tester Connection
Specified Condition
D15-4 (CG) - Body ground
Below 1 Ω
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BODY GROUND) |
Disconnect the power steering ECU connector.
Measure the resistance.

- Standard Resistance:
Tester Connection
Specified Condition
D31-11 (TS) - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 4. REPLACE POWER STEERING ECU |
Replace the power steering ECU.
Check for DTCs of the power steering ECU (Click here).
Result
Proceed to
DTC output
A
DTC not output
B
|
|
||||
| A | ||
| ||
