2005-2008 Yaris · Service Manual BRAKE

TC and CG Terminal Circuit

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the skid control ECU to display 2-digit DTCs by flashing the ABS warning light.

WIRING DIAGRAM

C118698E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (DLC3 - ECM)
  1. Turn the ignition switch off.

  1. Disconnect the ECM connector.

  1. H100178E01
    Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    D15-13 (TC) - A21-27 (TC)
    Below 1 Ω
    D15-13 (TC) - A32-7 (TC)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)

  1. F100115E26
    Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    D15-4 (CG) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (ECM - BODY GROUND)
  1. Disconnect the ECM connector.

  1. H100179E01
    Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    A21-27 (TC) - Body ground
    10 kΩ or higher
    A32-7 (TC) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. REPLACE ECM
  1. Replace the ECM.

  1. Check for DTCs of the ECM.

    Result
    Proceed to
    DTC output
    A
    DTC not output
    B

    HINT:
    1. 1KR-FE: (Click here)
    2. 2NZ-FE: (Click here)
    3. 1NZ-FE: (Click here)



B
END
A

REPAIR CIRCUITS INDICATED BY OUTPUT DTCS


← Skid Control Buzzer Circuit (from Aug 2005)TS and CG Terminal Circuit (from Aug 2005) →