2005-2008 Yaris · Service Manual ENGINE

P0106 Manifold Absolute Pressure / Barometric Pressure Circuit Range / Performance Problem

Diagnostic trouble codes · Vehicles built from Aug 2005

DESCRIPTION

Using built-in sensor unit, the manifold absolute pressure sensor detects the intake manifold pressure as a voltage. The ECM then determines the basic injection duration and basic ignition advance angle based on this voltage.
P001242E01
DTC No.
DTC Detection Condition
Trouble Area
P0106
  1. Difference between the intake manifold pressures before and after the engine start remains 50 kPa (375 mmHg) or less for 2 seconds or more. (1 trip detection logic).
  2. The pressure detected by the sensor is not within the standard range calculated from the engine speed and throttle opening angle. (1 trip detection logic).
  3. The sensor is frozen.
  1. Air induction system
  2. Manifold absolute pressure sensor

WIRING DIAGRAM

A109124E01

INSPECTION PROCEDURE

HINT:
Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.


1. CHECK ANY OTHER DTC OUTPUT (IN ADDITION TO P0106)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the intelligent tester ON.

  1. Select the following menu items: Powertrain / Engine and ECT / DTC.

  1. Read DTCs.

    Result:
    Display (DTC Output)
    Proceed To
    P0106
    A
    P0106 and other DTCs
    B

    HINT:
    If any DTCs other than P0106 is output, troubleshoot those DTCs first.



B
GO TO DTC CHART
A


2. READ VALUE OF MANIFOLD ABSOLUTE PRESSURE SENSOR
  1. Connect the intelligent tester to the DLC3.

  1. Warm up the engine.

  1. Turn the intelligent tester ON.

  1. Select the following menu items: Powertrain / Engine and ECT / Data List / MAP.

  1. Read the MAP value at idling and 2,500 rpm.

    Standard:
    Engine condition
    Tester Display
    Ignition switch on (IG)
    50 to 115 kPa
    Idling
    17 to 39 kPa
    2,500 rpm
    22 to 50 kPa



OK
GO TO CHECK FOR INTERMITTENT PROBLEMS
NG


3. CHECK AIR INDUCTION SYSTEM

  1. A104045
    Check the PCV hose.

    OK:
    The hose is not damaged and is securely connected.

  1. A104044
    Check the vacuum hoses.

    OK:
    The hoses are not damaged and are securely connected.

  1. Check the intake manifold.

    OK:
    The intake manifold is not cracked.



NG
REPAIR OR REPLACE AIR INDUCTION SYSTEM
OK

REPLACE MANIFOLD ABSOLUTE PRESSURE SENSOR


← P0011 Camshaft Position "A" - Timing Over-Advanced or System Performance (Bank 1) (+ P0012) (from Aug 2005)P0107 Manifold Absolute Pressure / Barometric Pressure Circuit Low Input (+ P0108) (from Aug 2005) →