2005-2008 Yaris · Service Manual ENGINE

FAIL-SAFE CHART

System information · Vehicles built from Aug 2005

If any of the following DTCs are recorded, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily.
DTC
Item
Fail-Safe Operation
Fail-Safe Deactivation Conditions
P0112 and P0113
Intake Air Temperature (IAT) sensor
ECM assumes that IAT is 20°C (68°F)
"Pass" condition detected
P0117 and P0118
Engine Coolant Temperature (ECT) sensor
ECM performs engine control using estimated ECT calculated from IAT at time of engine start and intake air volume
"Pass" condition detected
P0121, P0122, P0123, P0221, P0222 or P0223
Throttle Position (TP) sensor
ECM limits its accelerator pedal position sensor value to below 40%.
"Pass" condition detected and ignition switch off
P0135 and P0141
Heated Oxygen Sensor (HO2S) heater
If engine load is specific value or more, heater operates after specified length of time has elapsed
"Pass" condition detected
P0301, P0302 and P0303
Misfire detected
If misfire rate of cylinder exceeds catalytic damage misfire rate, fuel supply to that cylinder is suspended
"Pass" condition detected
P0327
Knock sensor
ECM sets ignition timing to maximum retard
"Pass" condition detected
P2111, P2101, P2102, P2103, P2118, P2129, P2109, P0606
Throttle control system
Power source of throttle control motor shut down, and engine speed is limited by fuel cut.
"Pass" condition detected and ignition switch off
P2122, P2123, P2128, P2127 or P2138
Accelerator position sensor
ECM limits its accelerator pedal position sensor value below 40%.
"Pass" condition detected and ignition switch off
"P2122 or P2123" and "P2128 or P2127 "
Accelerator position sensor
Drive with "First idle" condition
"Pass" condition detected and ignition switch off
← DTC CHECK / CLEAR (from Aug 2005)DATA LIST / ACTIVE TEST (from Aug 2005) →