2005-2008 Yaris · Service Manual ENGINE

P0121 Throttle / Pedal Position Sensor / Switch "A" Circuit Range / Performance Problem

Diagnostic trouble codes · Vehicles built from Nov 2005

CAUTION / NOTICE / HINT

HINT:
This DTC relates to the Throttle Position (TP) sensor.


DESCRIPTION

Refer to DTC P0120 (Click here).
DTC No.
DTC Detection Conditions
Trouble Areas
P0121
Difference between VTA1 and VTA2 voltages less than 0.8 V, or more than 1.6 V for 2 seconds (1 trip detection logic)
TP sensor (built into throttle body assembly)

FAIL-SAFE

When this DTC, or other DTCs relating to ETCS (Electronic Throttle Control System) malfunctions, are set, the ECM enters fail-safe mode. During fail-safe mode, the ECM cuts the current to the throttle actuator off, and the throttle valve is returned to a 8° throttle angle by the return spring. The ECM then adjusts the engine output by controlling the fuel injection (intermittent fuel-cut) and ignition timing, in accordance with the accelerator pedal opening angle, to allow the vehicle to continue at a minimal speed. If the accelerator pedal is depressed firmly and gently, the vehicle can be driven slowly. Fail-safe mode continues until a pass condition is detected, and the ignition switch is then turned off.

INSPECTION PROCEDURE

HINT:
Read freeze frame data using an intelligent tester. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.


1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0121)
  1. Connect an intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester on.

  1. Select the following menu items: Powertrain / Engine and ECT / DTC.

  1. Read DTCs.

Result:
Display (DTC Output)
Proceed To
P0121
A
P0121 and other DTCs
B



B
GO TO DTC CHART
A

REPLACE THROTTLE BODY ASSEMBLY


← P0120 Throttle / Pedal Position Sensor / Switch "A" Circuit (+ 6 more codes) (from Nov 2005)P0130 Oxygen Sensor Circuit Malfunction (Bank 1 Sensor 1) (+ P2195, P2196) (from Nov 2005) →