2005-2008 Yaris · Service Manual ENGINE

P0121 Throttle / Pedal Position Sensor / Switch "A" Circuit Range / Performance Problem

Diagnostic trouble codes · Vehicles built from Nov 2006

DESCRIPTION

HINT:
This DTC relates to the throttle position sensor.

Refer to DTC P0120 (Click here).
DTC No.
DTC Detection Condition
Trouble Area
P0121
Difference between VTA1 and VTA2 voltages is less than 0.8 V, or more than 1.6 V for 2 seconds
(1 trip detection logic)
Throttle position sensor (built into throttle body assembly)

FAIL-SAFE

When this DTC, as well as other DTCs relating to ETCS (Electronic Throttle Control System) malfunctions, is set, the ECM enters fail-safe mode. During fail-safe mode, the ECM cuts the current to the throttle actuator off, and the throttle valve is returned to a 6° throttle angle by the return spring. The ECM then adjusts the engine output by controlling the fuel injection (intermittent fuel-cut) and ignition timing, in accordance with the accelerator pedal opening angle, to allow the vehicle to continue at a minimal speed. If the accelerator pedal is depressed gently, the vehicle can be driven slowly. Fail-safe mode continues until a pass condition is detected, and the ignition switch is then turned off.

INSPECTION PROCEDURE

HINT:
Read freeze frame data using an intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.


1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0121)
  1. Connect an intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the tester on.

  1. Select the following menu items: Powertrain / Engine and ECT / DTC.

  1. Read DTCs.

    Result:
    Result
    Proceed to
    P0121
    A
    P0121 and other DTCs
    B

    HINT:
    If any DTCs other than P0121 are output, troubleshoot those DTCs first.



B
GO TO DTC CHART (Click here)
A

REPLACE THROTTLE BODY ASSEMBLY


← P0120 Throttle / Pedal Position Sensor / Switch "A" Circuit Malfunction (+ 6 more codes) (from Nov 2006)P0136 Oxygen Sensor Circuit Malfunction (Bank 1 Sensor 2) (+ P0137, P0138) (from Nov 2006) →