P0116 Engine Coolant Temperature Circuit Range / Performance Problem
Diagnostic trouble codes · Vehicles built from Nov 2006
DESCRIPTION
Refer to DTC P0115 (Click here).| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0116 |
Engine coolant temperature between -40°C and 60°C (-40°F and 140°F) when engine started, and conditions (a) and (b) met (2 trip detection logic):
|
|
INSPECTION PROCEDURE
- HINT:
- If any of DTCs P0115, P0117 or P0118 are set simultaneously with DTC P0116, the engine coolant temperature sensor may have an open or a short circuit. Troubleshoot those DTCs first.
- If any of DTCs P0115, P0117 or P0118 are set simultaneously with DTC P0116, the engine coolant temperature sensor may have an open or a short circuit. Troubleshoot those DTCs first.
- Read freeze frame data using an intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
- Read freeze frame data using an intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
| 1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0116) |
Connect an intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the tester on.
Select the following menu items: Powertrain / Engine and ECT / DTC.
Read DTCs.
- Result:
Result
Proceed to
P0116
A
P0116 and other DTCs
B
- HINT:
- If any DTCs other than P0116 are output, troubleshoot those DTCs first.
|
|
||||
| A | |
| 2. INSPECT THERMOSTAT |
Remove the thermostat (Click here).
Measure the valve opening temperature of the thermostat.
- Standard temperature:
- 80°C to 84°C (176°F to 183°F)
- HINT:
- In addition to the above check, confirm that the valve is completely closed when the temperature is below the standard.
Reinstall the thermostat (Click here).
|
|
||||
| OK | ||
| ||
