2005-2008 Yaris · Service Manual BODY

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2005

HINT:
  1. Use these procedures to troubleshoot the power window control system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      HINT:
      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT

    3.INSPECT COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*
    1. Using an intelligent tester, inspect LIN communication function to ensure there are no malfunctions in the communication system.

    2. ResultĀ 
      Result
      Proceed to
      No DTCs output
      A
      DTCs output
      B

    B.
    A

    4.PROBLEM SYMPTOMS TABLE
      ResultĀ 
      Result
      Proceed to
      Fault not listed in problem symptoms table
      A
      Fault listed in problem symptoms table
      B

    B.
    A

    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Data List/Active Test (Click here).

      1. Read the DATA LIST using an intelligent tester.

      2. Perform the ACTIVE TEST using an intelligent tester.

    2. Terminals of ECU (Click here).

    3. Operation check (Click here).

    NEXT

    6.ADJUST, REPAIR OR REPLACE
      NEXT

      7.CONFIRMATION TEST
        NEXT

        8.RESET POWER WINDOW MOTOR
        1. If a power window switch AUTO light is blinking, reset the power window motor (Click here).

        NEXT

        ← SYSTEM DESCRIPTION (from Aug 2005)OPERATION CHECK (from Aug 2005) →