P0505 Idle Control System Malfunction
Diagnostic trouble codes · Vehicles built from Nov 2006
DESCRIPTION
The idling speed is controlled by the Electronic Throttle Control System (ETCS). The ETCS is comprised of: 1) the one valve type throttle body; 2) the throttle actuator, which operates the throttle valve; 3) the throttle position (TP) sensor, which detects the opening angle of the throttle valve; 4) the accelerator pedal position (APP) sensor, which detects the accelerator pedal position; and 5) the ECM, which controls the ETCS. Based on the target idling speed, the ECM controls the throttle actuator to provide the proper throttle valve opening angle.| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0505 |
Idle speed continues to vary greatly from target speed (2 trip detection logic) |
|
INSPECTION PROCEDURE
- HINT:
- The following condition may also cause DTC P0505 to be set:
- The floor carpet overlapping onto the accelerator pedal, causing the accelerator pedal to be slightly depressed and therefore the throttle valve position to be slightly open.
- The accelerator pedal being not fully released.
- Read freeze frame data using an intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
- The following condition may also cause DTC P0505 to be set:
| 1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0505) |
Connect an intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the tester on.
Select the following menu items: Powertrain / Engine and ECT / DTC.
Read DTCs.
- Result:
Result
Proceed to
P0505
A
P0505 and other DTCs
B
- HINT:
- If any DTCs other than P0505 are output, troubleshoot those DTCs first.
|
|
||||
| A | |
| 2. CHECK PCV HOSE CONNECTIONS |
- OK:
- PCV hose is connected correctly and is not damaged.
|
|
||||
| OK | |
| 3. CHECK AIR INDUCTION SYSTEM |
Check the air induction system for vacuum leak.
- OK:
- No leak from air induction system.
|
|
||||
| OK | |
| 4. INSPECT THROTTLE BODY ASSEMBLY (THROTTLE VALVE) |
Check the throttle valve condition.
- OK:
- Throttle valve is not contaminated with foreign objects and moves smoothly.
|
|
||||
| OK | ||
| ||
