2005-2008 Yaris · Service Manual STEERING

DISASSEMBLY

Removal / installation · Vehicles built from Jan 2006


1. REMOVE STEERING SLIDING YOKE SUB-ASSEMBLY

G031118E01
  1. Place matchmarks on No. 2 steering intermediate shaft assembly and the steering sliding yoke.

  1. Remove bolt A and remove the steering sliding yoke from No. 2 steering intermediate shaft assembly.


2. REMOVE TRANSPONDER KEY AMPLIFIER

C119082E01
  1. Disengage the 2 claws and slide the transponder key amplifier in the direction shown in the illustration, to detach it from the steering column upper with switch bracket assembly.


3. REMOVE STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY
  1. Fix the steering post assembly in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Using a drill, drill a hole in each of the 2 steering lock set bolts, to insert an screw extractor.

  1. C103929
    Using the screw extractor, remove the 2 steering lock set bolts and remove the steering column upper with switch bracket assembly and steering column clamp upper.


4. REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY
  1. Turn the ignition switch to on (ACC).

  1. C105482E01
    Insert the tip of a screwdriver into the hole in the steering column bracket assembly upper, as shown in the illustration, and pull the ignition switch lock cylinder assembly out until its claw comes into contact with the stopper of the steering column bracket assembly upper.

    NOTICE:
    Pull the ignition switch lock cylinder assembly out until its claw comes into contact with the stopper of the steering column bracket assembly upper. Otherwise, the following procedure cannot be conducted properly.

  1. C119071E01
    Insert the tip of a screwdriver into the hole in the steering column bracket and tilt it downward, as shown in the illustration, to disengage the claw of the ignition switch lock cylinder. Then pull out the ignition switch lock cylinder.


5. REMOVE UN-LOCK WARNING SWITCH ASSEMBLY

C104851E01
  1. Push up the unlock warning switch assembly center portion to disengage the 2 claws.

    HINT:
    Slide the unlock warning switch assembly, in the direction shown by the arrow in the illustration, to remove it.


6. REMOVE KEY INTER LOCK SOLENOID

C104553
  1. for Automtic Transaxle:

    1. Remove the 2 screws and remove the key lock solenoid from the steering column bracket assembly upper.


7. REMOVE IGNITION OR STARTER SWITCH ASSEMBLY

C104552E01
  1. Disengage the 2 claws and remove the ignition (starter) switch assembly from the steering column bracket assembly upper.


8. REMOVE NO. 1 STEERING COLUMN PROTECTOR (for Manual Transaxle RHD)

C107904
  1. Fix the steering column in a vise between alminum plates.

    NOTICE:
    Do not over tighten the vise.

  1. Remove the bolt and remove No. 1 steering column protector.

← REMOVAL (from Jan 2006)REASSEMBLY (from Jan 2006) →