2005-2008 Yaris · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Jan 2006

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY

  1. B134970E01
    Using an air riveter or hand riveter, install the front No. 1 speaker with 3 new strike rivets.

    HINT:
    Install the new strike rivets in the order shown in the illustration.

    NOTICE:

    1. B130465
      Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

    2. B130466
      Confirm that the rivets are seated properly against the speaker.
    3. Do not tilt the riveter when installing the rivet onto the speaker.
    4. Do not leave any space between the rivet head and speaker.

    5. B130467
      Do not leave any space between the speaker and door. Firmly hold the 2 items together while installing the rivet.

  1. B134972
    Connect the speaker connector.


2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

HINT:
Use the same procedure as for the LH side (Click here).


3. INSTALL FRONT DOOR ARMREST BASE UPPER PANEL

HINT:
Use the same procedure as for the LH side (Click here).


4. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

HINT:
Use the same procedure as for the LH side (Click here).


5. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

HINT:
Use the same procedure as for the LH side (Click here).


6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

← REMOVAL (from Jan 2006)COMPONENTS (from Aug 2005) →