C0278/11 Open or Short Circuit in ABS Solenoid Relay Circuit
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
The solenoid relay supplies power to the ABS solenoid and TRC solenoid.After the ignition switch is turned on (IG), the vehicle speed has reached 6 km/h (4 mph) and the solenoid is determined to be normal by the initial check self-diagnosis, the relay switches on. If any open or short circuits are detected, the relay switches off.
These DTCs may be set if the voltage supply to the solenoid relay (+BS) falls below the DTC detection threshold due to the battery or alternator outputs being insufficient.
| DTC No. |
DTC Detecting Conditions |
Trouble Areas |
| C0278/11 |
When either of following conditions (1 or 2) detected:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT FUSE (ABS2/VSC2) |
Remove the ABS2/VSC2 fuse from the engine room R/B.

Measure the resistance.
- Standard Resistance:
- Below 1 Ω
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (BATTERY - SKID CONTROL ECU - BODY GROUND) |
Disconnect the skid control ECU connector.

Measure the voltage.
- Standard Voltage:
Tester Connection
Specified Condition
A39-14 (+BS) - Body ground
10 to 14 V
Measure the resistance.
- Standard Resistance:
Tester Connection
Specified Condition
A39-13 (GND1) - Body ground
Below 1 Ω
A39-26 (GND2) - Body ground
Below 1 Ω
|
|
||||
| OK | |
| 3. RECONFIRM DTC |
Clear the DTCs (Click here).
Start the engine.
Check if the same DTCs are output (Click here).
- Result:
Result
Proceed to
DTC output
A
DTC not output
B
|
|
||||
| A | ||
| ||
