2005-2008 Yaris · Service Manual BRAKE

C1241/41 Low Battery Positive Voltage or Abnormally High Battery Positive Voltage

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

When there is an abnormality in the power supply circuit of the brake actuator (skid control ECU), the skid control ECU sets a DTC and the operation is prohibited by the fail-safe function. This DTC is set when the voltage supplied to terminal +BS is outside the DTC detection threshold, due to abnormalities of the battery, power source circuits or charging circuits such as the alternator circuit.
The fail-safe function is canceled when the voltage to terminal +BS returns to normal.
DTC No.
DTC Detecting Conditions
Trouble Areas
C1241/41
When any of following conditions detected:
  1. +BS terminal voltage 18 V or more, even momentarily.
  2. At vehicle speed 20 km/h (12 mph) or more, +BS terminal voltage 9.7 V or less for 0.021 seconds or more.
  3. At vehicle speed 20 km/h (12 mph) or more, +BS terminal voltage 7.5 V or less, even momentarily.
  1. Battery
  2. Charging system
  3. Power source circuit
  4. Internal power supply circuit of skid control ECU

WIRING DIAGRAM

Click here.

INSPECTION PROCEDURE


1. INSPECT BATTERY
  1. Check the battery voltage.

    Standard Voltage:
    11 to 14 V



NG
CHECK CHARGING SYSTEM
OK


2. INSPECT FUSES (ABS2/VSC2)

  1. C117851E04
    Remove the ABS2/VSC2 fuse from the engine room R/B.

  1. Measure the resistance.

    Standard Resistance:
    Below 1 Ω



NG
CHECK FOR SHORTS IN ALL HARNESSES AND CONNECTORS CONNECTED TO FUSE AND REPLACE FUSE
OK


3. CHECK HARNESS AND CONNECTOR (BATTERY - SKID CONTROL ECU - BODY GROUND)

  1. C129347E02
    Disconnect the skid control ECU connector.

  1. Measure the voltage.

    Standard Voltage:
    Tester Connection
    Specified Condition
    A39-14 (+BS) - Body ground
    10 to 14 V

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    A39-13 (GND1) - Body ground
    Below 1 Ω
    A39-26 (GND2) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Check if the same DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE BRAKE ACTUATOR


← C0278/11 Open or Short Circuit in ABS Solenoid Relay Circuit (from Nov 2005)C1249/49 Open in Stop Light Switch Circuit (from Nov 2005) →