2005-2008 Yaris · Service Manual COMMUNICATION SYSTEM

Steering Angle Sensor Communication Stop Mode

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

Detection Item
Symptom
Trouble Area
Steering Angle Sensor Communication Stop Mode
  1. "Steering Angle Sensor" not displayed on "Communication Bus Check" screen of intelligent tester.
  1. Applies to "Steering Angle Sensor Communication Stop Mode" in "DTC combination table"
  1. Power source circuit of steering sensor
  1. Steering sensor branch wire or connector
  2. Steering sensor

HINT:
For vehicle with VSC only.


WIRING DIAGRAM

C120497E04

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the CAN main wire and the CAN branch wire.
  2. After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

    HINT:
    Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. CHECK CAN BUS LINE FOR DISCONNECTION (STEERING SENSOR BRANCH WIRE)

  1. G030155E25
    Turn the ignition switch off.

  1. Disconnect the D62 steering sensor connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D62-10 (CANH) - D62-9 (CANL)
    Ignition Switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO STEERING SENSOR (CAN-H, CAN-L)
OK


2. CHECK HARNESS AND CONNECTOR (IG, ESS)

  1. G030155E26
    Disconnect the D62 steering sensor connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D62-2 (ESS) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D62-1 (IG) - Body ground
    Ignition Switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE STEERING SENSOR


← Power Steering ECU Communication Stop Mode (from Aug 2005)Yaw Rate Sensor Communication Stop Mode (from Aug 2005) →