2005-2008 Yaris · Service Manual COMMUNICATION SYSTEM

Power Steering ECU Communication Stop Mode

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

Detection Item
Symptom
Trouble Area
Power Steering ECU Communication Stop Mode
  1. "EPS" not displayed on "Communication Bus Check" of intelligent tester
  2. Applies to "Power Steering ECU Communication Stop Mode" in "DTC combination table"
  1. Power source circuit of power steering ECU
  2. Power steering ECU main wire or connector
  3. Power steering ECU

WIRING DIAGRAM

C120497E03

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the CAN main wire and the CAN branch wire.
  2. After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

    HINT:
    Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. CHECK HARNESS AND CONNECTOR (IG, PGND)

  1. C118163E01
    Disconnect the D31 and A19 power steering ECU connectors.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A19-2 (PGND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D31-6 (IG) - Body ground
    Ignition Switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER STEERING ECU


← Air Conditioning Amplifier Communication Stop Mode (from Aug 2005)Steering Angle Sensor Communication Stop Mode (from Aug 2005) →