MIL Circuit
Circuit diagnosis · Vehicles built from Nov 2005
DESCRIPTION
The MIL (Malfunction Indicator Lamp) is used to indicate vehicle malfunctions detected by the ECM. When the ignition switch is turned on (IG), power is supplied to the MIL circuit, and the ECM provides the circuit ground which illuminates the MIL.The MIL operation can be checked visually: When the ignition switch is first turned on (IG), the MIL should be illuminated and should then turn off. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using an intelligent tester.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK THAT MIL IS ILLUMINATED |
Perform troubleshooting in accordance with the table below.
Conditions
Proceed To
MIL remains ON
A
MIL does not illuminate
B
|
|
||||
| A | |
| 2. CHECK WHETHER MIL TURNS OFF |
Connect an intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester on.
Select the following menu items: Powertrain / Engine and ECT / DTC.
Check if any DTCs have been stored. Note down any DTCs.
Clear DTCs (Click here).
Check if the MIL goes off.
- Standard:
- MIL should go off.
|
|
||||
| NG | |
| 3. CHECK HARNESS AND CONNECTOR (CHECK FOR SHORT IN WIRE HARNESS) |
![]() ![]() |
Disconnect the A21 ECM connector.
Turn the ignition switch on (IG).
Check that the MIL is not illuminated.
- OK:
- MIL is not illuminated.
Reconnect the ECM connector.
|
|
||||
| NG | |
| 4. CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM) |
![]() ![]() |
Disconnect the A21 ECM connector.
Disconnect the D2 combination meter connector.
Check the resistance.
- Standard resistance (Check for short):
Tester Connections
Specified Conditions
W (A21-24) or combination meter (D2-4 or D2-5) - Body ground
10 kΩ or higher
Reconnect the ECM connector.
Reconnect the combination meter connector.
|
|
||||
| NG | ||
| ||
| 5. CHECK THAT MIL IS ILLUMINATED |
Check if the MIL is illuminated when the ignition switch is turned on (IG).
- OK:
- MIL should be illuminated.
|
|
||||
| NG | |
| 6. CHECK THAT ENGINE STARTS |
Turn the ignition switch on (IG).
Start the engine.
Result
Proceed To
Engine starts
A
Engine does not start*
B
- HINT:
- *: The intelligent tester cannot communicate with the ECM.
|
|
||||
| A | |
| 7. INSPECT COMBINATION METER ASSEMBLY (MIL CIRCUIT) |
Check the MIL circuit (Click here).
|
|
||||
| OK | ||
| ||


