DTC output mode is set by connecting terminals TC and CG of the DLC3. The DTCs are displayed by blinking the SRS warning light.
HINT:
Make sure that DTCs which relate to the CAN communication system are not output. If any of these DTCs are output, check the CAN communication system (Click here).
When a warning light keeps blinking, a short to ground in the wiring of terminal TC of the DLC3 or an internal ground short in an ECU is suspected.
The DTC output mode signal is transmitted through the CAN to each ECU including the center airbag sensor assembly. Thus when no systems enter DTC output mode, the ECM may have a malfunction.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK HARNESS AND CONNECTOR (DLC3 - ECM)
Turn the ignition switch off.
Disconnect the connector from the ECM.
Measure the resistance.
Standard resistance:
Tester connection
Condition
Specified condition
D15-13 (TC) - A21-27 (TC) (*1)
Always
Below 1 Ω
D15-13 (TC) - A32- 7 (TC) (*2)
Always
Below 1 Ω
D51-13 (TC) - A49-28 (TC)(*3)
Always
Below 1 Ω
*1: 1NZ-FE, 2NZ-FE, 2SZ-FE, 2ZR-FE*2: 1KR-FE*3: 1ND - TV
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (TC OF DLC3 - TC OF ECM)
OK
2. CHECK HARNESS AND CONNECTOR (CG OF DLC3 - BODY GROUND)
Measure the resistance.
Standard resistance:
Tester connection
Condition
Specified condition
D15-4 (CG) - Body ground
Always
Below 1 Ω
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (CG OF DLC3 - BODY GROUND)