2005-2008 Yaris · Service Manual BODY ELECTRICAL

Entry Functions do not Operate at All

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

When the entry functions do not operate at all, it is possible that the certification ECU is malfunctioning or that the wire harness leading to the certification ECU is short-circuited.

INSPECTION PROCEDURE


1. CHECK KEY CANCEL FUNCTION
  1. Check that the key cancel function has been set.

    OK:
    Key cancel function is set.



OK
END (UNSET KEY CANCEL FUNCTION)
NG


2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU ASSEMBLY - BATTERY AND BODY GROUND)
B107456E30
  1. Disconnect the D60 ECU connector.

  1. Measure the voltage and resistance of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D60-18 (IG) - Body ground
    Ignition switch off
    Below 1 V
    D60-18 (IG) - Body ground
    Ignition switch on (IG)
    10 to 14 V
    D60-1 (+B1) - Body ground
    Always
    10 to 14 V

    Standard resistance:
    Tester Connection
    Specified Condition
    D60-17 (E) - Body ground
    Below 1 Ω

  1. Reconnect the ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CERTIFICATION ECU ASSEMBLY


← Entry Interior Alarm does not Sound (from Aug 2005)Back Door Entry Unlock Function does not Operate (from Aug 2005) →