2005-2008 Yaris · Service Manual STEERING

B2781 Open / Short in Steering Lock ECU

Diagnostic trouble codes · Vehicles built from Aug 2005

DESCRIPTION

The steering lock ECU and steering lock actuator assembly are supplied as a unit.
The steering lock ECU detects the steering lock position through the signals from the lock and unlock sensors.
The steering lock ECU activates the steering lock motor based on permission signals from the main body ECU and the certification ECU.
The diagnosis information of the steering lock ECU is transmitted to the tester via the certification ECU as the steering lock ECU is not connected to the CAN communication system.
DTC No.
DTC Detecting Condition
Trouble Area
B2781
  1. Steering lock motor drive power circuit malfunction
  2. Both lock and unlock position sensors detect [ON]
  1. Steering lock actuator assembly (Steering lock ECU)
  2. Harness or connector of LIN bus line
  3. Certification ECU

INSPECTION PROCEDURE

HINT:
  1. Before starting the inspection by using the intelligent tester with the engine switch off, make sure that the driver door is open.
  2. When the engine switch is off, the main body ECU may not be working.
  3. Communication with the intelligent tester is impossible if the main body ECU is not working.


1. CHECK DTC (CERTIFICATION ECU)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the tester on.

  1. Read the DTCs of the certification ECU by following the prompts displayed on the intelligent tester.

OK:
DTC B2785 that indicates malfunctions in LIN bus line, is not output.

HINT:
If DTC B2785 is output, inspect LIN communication system (Click here ).



NG
INSPECT COMMUNICATION SYSTEM (LIN)
OK

REPLACE STEERING LOCK ACTUATOR ASSEMBLY


← DIAGNOSTIC TROUBLE CODE CHART (from Aug 2005)B2782 Power Source Control ECU Malfunction (from Aug 2005) →