2005-2008 Yaris · Service Manual SECURITIES

B2785 Communication Malfunction between ECUs Connected by LIN

Diagnostic trouble codes · Vehicles built from Aug 2005

DESCRIPTION

  1. The certification ECU communicates with the main body ECU, ID code box, and steering lock actuator (steering lock ECU) through the LIN communication system.
  2. B2785 is output when the communication among the certification ECU, main body ECU, ID code box, and steering lock actuator (steering lock ECU) stops for 2.4 seconds or more.
DTC No.
DTC Detection Condition
Trouble Area
B2785
LIN communication from certification ECU stops for certain amount of time
  1. Certification ECU
  2. ID code box
  3. Main body ECU
  4. Steering lock ECU
  5. Open or short in wire harness between ECUs

WIRING DIAGRAM

I100645E03

INSPECTION PROCEDURE


1. CHECK DTC
  1. Clear the DTC (Click here).

  1. Recheck for DTC.

    Result: 
    Result
    Proceed to
    B2785 output recurs
    A
    B2785 output does not recur
    B



B
NORMAL
A


2. CHECK HARNESS AND CONNECTOR (LIN COMMUNICATION LINE AND BODY GROUND)
B122832E01
  1. Disconnect the D56, D58, D60 and 4D ECU connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    D60-10 (LIN) - D58-3 (LIN1)
    Below 1 Ω
    D60-10 (LIN) - 4D-9 (LIN1)
    Below 1 Ω
    D60-10 (LIN) - D56-5 (LIN)
    Below 1 Ω
    D60-10 (LIN), D58-3 (LIN1), 4D-9 (LIN1) or D56-5 (LIN) - Body ground
    10 kΩ or higher

  1. Reconnect the ECU connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK OPERATION OF CERTIFICATION ECU
  1. After replacing the certification ECU with a normal one, check for DTC.

    Result: 
    Result
    Proceed to
    B2785 output recurs
    A
    B2785 output does not recur
    B



B
REPLACE CERTIFICATION ECU
A


4. CHECK OPERATION OF MAIN BODY ECU
  1. After replacing the main body ECU with a normal one, check for DTC.

    Result: 
    Result
    Proceed to
    B2785 output recurs
    A
    B2785 output does not recur
    B



B
REPLACE MAIN BODY ECU
A


5. CHECK STEERING LOCK ECU
  1. After replacing the steering control ECU with a normal one, check for DTC.

    Result: 
    Result
    Proceed to
    B2785 output recurs
    A
    B2785 output does not reocur
    B



B
REPLACE STEERING LOCK ECU
A

REPLACE ID CODE BOX


← B2784 Antenna Coil Open / Short (from Aug 2005)B2789 No Response from ID BOX (from Aug 2005) →