2005-2008 Yaris · Service Manual STEERING

B2788 IG2 Signal Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2005

DESCRIPTION

The steering lock ECU determines the on (IG) / off status of the engine switch through the IG2 signal circuit. On receiving an IG2 relay ON signal, the steering lock ECU determines that the vehicle is moving. The steering lock ECU does not lock the steering when it receives an IG2 relay ON signal to prevent the steering from being locked while the vehicle is moving.
The diagnosis information of the steering lock ECU is transmitted to the tester via the certification ECU as the steering lock ECU is not connected to the CAN communication system.
DTC No.
Detection Item
Trouble Area
B2788
Open or short in IG2 signal circuit
  1. Harness or connector
  2. Steering lock actuator assembly (Steering lock ECU)
  3. IG2 relay circuit

WIRING DIAGRAM

C122326E01

INSPECTION PROCEDURE

HINT:
  1. Before starting the inspection by using the intelligent tester with the engine switch off, make sure that the driver door is open.
  2. When the engine switch is off, the main body ECU may not be working.
  3. Communication with the intelligent tester is impossible if the main body ECU is not working.


1. INSPECT STEERING LOCK ACTUATOR ASSEMBLY

  1. C104383E03
    Measure the voltage.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    IG2 (D56-6) - Body ground
    Engine switch on (IG)
    10 to 14 V
    IG2 (D56-6) - Body ground
    Engine switch off
    Below 1 V



NG
INSPECT RELAY CIRCUIT (IG2 RELAY)
OK


2. CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - BODY GROUND)

  1. C122327E02
    Disconnect the connector from the steering lock actuator assembly.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    GND (D56-1) - Body ground
    Always
    Below 1 Ω
    SGND (D56-2) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE STEERING LOCK ACTUATOR ASSEMBLY


← B2786 No Response from Steering Lock ECU (from Aug 2005)Steering Lock Motor Drive Power Circuit (Aug 2005 – Oct 2005) →