2005-2008 Yaris · Service Manual STEERING

B2786 No Response from Steering Lock ECU

Diagnostic trouble codes · Vehicles built from Aug 2005

DESCRIPTION

This DTC is output when the certification ECU does not receive LIN communication signals from the steering lock ECU for 10 seconds.
The diagnosis information of the steering lock ECU is transmitted to the tester via the certification ECU as the steering lock ECU is not connected to the CAN communication system.
DTC No.
DTC Detection Condition
Trouble Area
B2786
Certification ECU does not receive LIN communication signals from steering lock ECU for 10 seconds
  1. Wire harness
  2. Certification ECU
  3. Steering lock actuator assembly (Steering lock ECU)

WIRING DIAGRAM

I100646E03

INSPECTION PROCEDURE

HINT:
  1. Before starting the inspection by using the intelligent tester with the engine switch off, make sure that the driver door is open.
  2. When the engine switch is off, the main body ECU may not be working.
  3. Communication with the intelligent tester is impossible if the main body ECU is not working.


1. CHECK DTC
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the tester on.

  1. Clear the DTCs of the certification ECU by following the prompts displayed on the intelligent tester.

  1. Recheck for DTCs.

    Result: 
    Result
    Proceed to
    B2786 output reoccurs
    A
    B2786 output does not reoccur
    B



B
CHECK INTERMITTENT PROBLEMS
A


2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - STEERING LOCK ECU)
B108730E06
  1. Disconnect the connectors from the certification ECU and the steering lock actuator assembly.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    LIN (D60-10) - LIN (D56-5)
    Below 1 Ω
    LIN (D56-5) - Body ground
    10 kΩor higher

  1. Reconnect the connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK DTC (CERTIFICATION ECU)
  1. After replacing the certification ECU with a normal one, check for DTCs.

    Result: 
    Result
    Proceed to
    B2786 output reoccurs
    A
    B2786 output does not reoccur
    B



B
REPLACE CERTIFICATION ECU
A

REPLACE STEERING LOCK ACTUATOR ASSEMBLY


← B2782 Power Source Control ECU Malfunction (from Aug 2005)B2788 IG2 Signal Malfunction (from Aug 2005) →