2005-2008 Yaris · Service Manual SECURITIES

B2797 Communication Malfunction No. 1

Diagnostic trouble codes · Vehicles built from Aug 2005

DESCRIPTION

This DTC is output when a communication error occurs between the transponder key amplifier and transponder key ECU. Some possible reasons for the communication error are: 1) 2 or more ignition keys are positioned too close together, or 2) noise is occurring in the communication line.
DTC No.
DTC Detection Condition
Trouble Area
B2797
Keys are positioned too close to each other, or noise occurred in communication line
  1. Key
  2. Wire harness
  3. Transponder key amplifier
  4. Transponder key ECU assembly

WIRING DIAGRAM

B052550E08

INSPECTION PROCEDURE


1. CHECK KEYS

  1. B072873
    Check if the ignition key being used is near other ignition keys, as shown in the illustration. Also, check if the key ring is in contact with the key grip.

    Result:
    Result
    Proceed to
    Key is near other keys and/or key ring is in contact with key grip.
    A
    Key is not near other keys and/or key ring is not in contact with key grip.
    B



B
Go to step 3
A


2. CHECK DTC
  1. Separate the keys from each other and/or remove the key ring.

  1. Clear the DTC (Click here).

  1. Insert a key into the ignition cylinder. Remove it. Repeat for all other keys.

  1. Check that no DTC is output.

    OK:
    No DTC is output.



NG
Go to step 3
OK

NORMAL (INSPECTION FINISHED)

3. CHECK TRANSPONDER KEY ECU ASSEMBLY

  1. B050157E02
    Using an oscilloscope or the intelligent tester, check for noise in the waveform between the terminals of the D24 amplifier connector and D23 ECU connector.

    Standard:
    Tester Connection
    Specified Condition
    D23-15 (CODE) - D24-4 (CODE)
    No noise is present

    Tool Setting
    5 V/DIV., 20 ms/DIV.
    Condition
    Ignition switch
    OFF → ON



NG
FIND CAUSE OF NOISE AND REMOVE IT
OK


4. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER)

  1. B110403E05
    Disconnect the D23 transponder key ECU connector.

  1. Disconnect the D24 transponder key amplifier connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    D23-15 (CODE) - D24-4 (CODE)
    Below 1 Ω

  1. Reconnect the transponder key ECU and transponder key amplifier connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5. REPLACE TRANSPONDER KEY AMPLIFIER
  1. After replacing the transponder key amplifier with a normally functioning amplifier, check that the engine starts.

    OK:
    Engine starts.



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY
OK

NORMAL (TRANSPONDER KEY AMPLIFIER DEFECT)


← B2796 No Communication in Immobiliser System (+ B2798) (from Aug 2005)B2799 Engine Immobiliser System Malfunction (from Aug 2005) →