B2799 Engine Immobiliser System Malfunction
Diagnostic trouble codes · Vehicles built from Aug 2005
DESCRIPTION
This DTC is output when: 1) the ECM detects errors in its own communications with the transponder key ECU; 2) the ECM detects errors in the communication lines; and 3) the ECU communication ID between the transponder key ECU and the ECM are different and an engine start is attempted.Before troubleshooting for this DTC, make sure no transponder key ECU DTCs are present. If present, troubleshoot the transponder key ECU DTCs first.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2799 |
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - ECM) |
Disconnect the D23 transponder key ECU connector.

Disconnect the A21 (1NZ-FE, 2NZ-FE, 2SZ-FE and 2ZR-FE), A32 (1KR-FE) or A49 (1ND-TV) ECM connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
1NZ-FE, 2NZ-FE, 2SZ-FE and 2ZR-FE Tester Connection
Specified Condition
D23-13 (EFIO) - A21-11 (IMI)
Below 1 Ω
D23-12 (EFII) - A21-10 (IMO)
Below 1 Ω
D23-11 (EGND) - A21-9 (EOM)
Below 1 Ω
D23-13 (EFIO) or A21-11(IMI) -
Body ground
10 kΩ or higher
D23-12 (EFII) or A21-10(IMO) -
Body ground
10 kΩ or higher
1KR-FE Tester Connection
Specified Condition
D23-13 (EFIO) - A32-31 (IMI)
Below 1 Ω
D23-12 (EFII) - A32-40 (IMO)
Below 1 Ω
D23-13 (EFIO) or A32-31(IMI) -
Body ground
10 kΩ or higher
D23-12 (EFII) or A32-40 (IMO) -
Body ground
10 kΩ or higher
1ND-TV Tester Connection
Specified Condition
D23-13 (EFIO) - A49-6 (IMI)
Below 1 Ω
D23-12 (EFII) - A49-4 (IMO)
Below 1 Ω
D23-13 (EFIO) or A49-6 (IMI) -
Body ground
10 kΩ or higher
D23-12 (EFII) or A49-4 (IMO) -
Body ground
10 kΩ or higher
|
|
||||
| OK | ||
| ||
