2005-2008 Yaris · Service Manual SECURITIES

Horn Circuit

Circuit diagnosis · Vehicles built from Nov 2006

DESCRIPTION

When the theft deterrent system is changed from the armed state to the alarm sounding state, the theft warning ECU turns on the HORN relay so that the horn can sound. The horn cycles between ON and OFF at intervals of approximately 0.4 seconds.

WIRING DIAGRAM

B165818E01

INSPECTION PROCEDURE


1. CHECK HORN ASSEMBLY
  1. Press the horn switch and check if the horns sound.

    Result:
    Result
    Proceed to
    Horns sound
    A
    Horns do not sound
    B



B
GO TO HORN SYSTEM
A


2. CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU ASSEMBLY - INTEGRATION RELAY (HORN RELAY) AND BATTERY)

  1. B165850E01
    Disconnect the D86 theft warning ECU.

  1. Remove the integration relay from the engine room R/B.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance (Check for open):
    Tester Connection
    Specified Condition
    D86-31 (HORN) - 1A-7 (Integration relay)
    Below 1 Ω

    Standard resistance (Check for short):
    Tester Connection
    Specified Condition
    D86-31 (HORN) - Body ground
    10 kΩ or higher

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    1C-1 (Integration relay) - Body ground
    Always
    11 to 14 V

  1. Reconnect the theft warning ECU connector.

  1. Reinstall the integration relay.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY


← Engine Hood Courtesy Switch Circuit (from Nov 2006)Security Horn Circuit (from Nov 2006) →