2005-2008 Yaris · Service Manual SECURITIES

Security Horn Circuit

Circuit diagnosis · Vehicles built from Nov 2006

DESCRIPTION

When the theft deterrent system is changed from the armed state to the alarm sounding state, the theft warning ECU can sound the security horn. The horn cycles between ON and OFF at intervals of approximately 0.4 seconds.

WIRING DIAGRAM

B165763E01

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SECURITY HORN)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the intelligent tester main switch ON.

  1. Select the item below in the ACTIVE TEST and then check that the horn operates.

    Theft Warning ECU: 
    Item
    Test Details
    Diagnostic Note
    Security Horn
    Security horn ON/OFF
    -

    OK:
    Security horn operates normally.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

2. INSPECT FUSE (ECU-B)
  1. Remove the ECU-B fuse from the engine room R/B.

  1. Check the resistance.

    Standard resistance:
    Below 1 Ω

  1. Reinstall the ECU-B fuse.



NG
REPLACE FUSE
OK


3. CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU ASSEMBLY- BODY GROUND)

  1. B121327E15
    Disconnect the D86 theft warning ECU connector.

  1. Check the voltage.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D86-13 (+B2) - Body ground
    Always
    11 to 14 V

  1. Reconnect the theft warning ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. INSPECT SECURITY HORN ASSEMBLY

  1. B121333E01
    Disconnect the A57 security horn connector.

  1. Check the operation of the security horn.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Security horn sounds

  1. Reconnect the security horn connector.



NG
REPLACE SECURITY HORN ASSEMBLY
OK


5. CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU ASSEMBLY - SECURITY HORN ASSEMBLY)
  1. Disconnect the D86 theft warning ECU and the A57 security horn connectors.

  1. B121334E04
    Check the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    D86-15 (SH-) - A57-1
    Below 1 Ω
    A57-2 - Body ground
    Below 1 Ω
    D86-15 (SH-) or (A57-1) - Body ground
    10 kΩ or higher

  1. Reconnect the theft warning ECU and the security horn connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY


← Horn Circuit (from Nov 2006)Ignition Switch Circuit (from Nov 2006) →