2005-2008 Yaris · Service Manual SECURITIES

Security Indicator Light Circuit

Circuit diagnosis · Vehicles built from Nov 2006

DESCRIPTION

While the theft deterrent system is preparing itself to be set, this circuit lights up the security indicator light. When the system is set, it continuously turns the indicator light on for 0.2 seconds and then turns it off for 1.8 seconds, thus the indicator light blinks.

WIRING DIAGRAM

B122658E03

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SECURITY INDICATOR LIGHT)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the intelligent tester main switch ON.

  1. Select the item below in the ACTIVE TEST and then check that the security indicator operates.

    Theft Warning ECU:
    Item
    Test Details
    Diagnostic Note
    Security Indicator
    Security indicator light ON/OFF
    -

    OK:
    The security indicator light turns on and off correctly when it is operated through the intelligent tester.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

2. CHECK SECURITY INDICATOR LIGHT ASSEMBLY

  1. E108193E04
    Disconnect the D25 security indicator light connector.

  1. Apply battery voltage to the terminals of the security indicator and check the lighting condition.

    OK:
    Measurement Condition
    Specified Operation
    Battery positive (+) - Terminal 2
    Battery negative (-) - Terminal 6
    Indicator light comes on.

  1. Reconnect the indicator light connector.



NG
REPLACE SECURITY INDICATOR LIGHT ASSEMBLY
OK


3. CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU - SECURITY INDICATOR LIGHT ASSEMBLY)

  1. B122659E03
    Disconnect the D86 theft warning ECU and the D25 security indicator light connectors.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    D86-29 (IND) - D25-2
    Below 1 Ω
    D86-29 (IND) - Body ground
    10 kΩ or higher

  1. Reconnect the theft warning ECU and the security indicator light connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR LIGHT ASSEMBLY - BODY GROUND)
  1. Disconnect the D25 security indicator light connector.

  1. B122660E01
    Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    D25-6 - Body ground
    Below 1 Ω

  1. Reconnect the security indicator light connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY


← Ignition Switch Circuit (from Nov 2006)ECU Power Source Circuit (from Nov 2006) →