2005-2008 Yaris · Service Manual TRANSMISSION

Shift Lock Solenoid Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

The shift lock solenoid is built into the shift lever assembly. When the ignition switch is turned off, or when the shift lever is in the N position without depressing the brake pedal although the ignition switch is turned on (IG), the shift lock solenoid restricts the shift lever movement.
The transmission control ECU sends the shift lock cancellation signal to the shift lock solenoid to cancel the shift lock when the multi-mode manual transmission system conditions are satisfied.

WIRING DIAGRAM

C111580E01

INSPECTION PROCEDURE


1. INSPECT SHIFT LOCK SOLENOID
C112727E04
  1. Disconnect the shift lever assembly connector.

  1. Measure the shift lock solenoid resistance.

    Standard resistance:
    Tester Connections
    Specified Conditions
    IG (D81-2) - E (D81-6)
    30 to 35 Ω at 20°C (68°F)



NG
REPLACE SHIFT LOCK SOLENOID
OK


2. CHECK HARNESS AND CONNECTOR (SHIFT LOCK SOLENOID - TRANSMISSION CONTROL ECU, BODY GROUND)
C113923E05
  1. Disconnect the shift lever assembly connector.

  1. Disconnect the transmission control ECU connector.

  1. Check the resistance.

    Standard resistance:
    Tester Connections
    Specified Conditions
    SLS (D79-5) - IG (D81-2)
    Below 1 Ω
    E (D81-6) - Body ground
    Below 1 Ω
    SLS (D79-5) - Body ground
    10 kΩ or higher

  1. Reconnect the transmission control ECU connector.

  1. Reconnect the shift lever assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT TRANSMISSION CONTROL ECU ASSEMBLY
C112714E19
  1. Turn the ignition switch on (IG).

  1. Measure the voltage between the terminal of the transmission control ECU and the body ground when the brake pedal is operated.

    Standard voltage:
    Pedal Conditions
    Tester Connections
    Specified Conditions
    Brake pedal depressed
    SLS (D79-5) - Body ground
    10 to 14 V
    Brake pedal released
    SLS (D79-5) Body ground
    Below 1 V



NG
REPLACE TRANSMISSION CONTROL ECU ASSEMBLY
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← IG Signal Circuit (from Nov 2005)Multi-Mode Manual Transmission Warning Light Circuit (from Nov 2005) →