2005-2008 Yaris · Service Manual TRANSMISSION

CALIBRATION

Troubleshooting · Vehicles built from Nov 2005


SYNCHRONIZATION POSITION CALIBRATION
For smoother shifting, the transmission control ECU learns the synchronization position of the transmission gears. Perform the synchronization position calibration of the multi-mode manual transmission while driving the vehicle after repairing system components.

HINT:
When replacing the following parts, proceed with the operation in the order listed in the table below.

Parts installed
Operation order
See procedure
  1. Transmission assembly
  2. Transmission parts (inside gear box)
  3. Shift and select actuator (with clutch actuator)
  4. Transmission control ECU
1. INITIALIZATION OF MULTI-MODE MANUAL TRANSMISSION SYSTEM
[Initialization of ECU]
Click here
2. LEARNING OF MULTI-MODE MANUAL TRANSMISSION SYSTEM
Click here
3. SYNCHRONIZATION POSITION CALIBRATION
See below
  1. Shift stroke sensor
  2. Select stroke sensor
1. INITIALIZATION OF MULTI-MODE MANUAL TRANSMISSION SYSTEM
[Initialization of transmission]
Click here
2. LEARNING OF MULTI-MODE MANUAL TRANSMISSION SYSTEM
Click here
3. SYNCHRONIZATION POSITION CALIBRATION
See below
  1. Clutch actuator
  2. Clutch stroke sensor
  3. Clutch disc and clutch cover
  4. Clutch release bearing
  5. Clutch release fork
  6. Clutch release lever
  7. Flywheel
  8. End plate (2SZ-FE only)
  9. Crankshaft
1. INITIALIZATION OF MULTI-MODE MANUAL TRANSMISSION SYSTEM
[Initialization of clutch]
Click here
2. LEARNING OF MULTI-MODE MANUAL TRANSMISSION SYSTEM
Click here
  1. While driving the vehicle in M-mode, shift up and down between 1st and 5th at the vehicle speeds specified below.

  2. Check that the gears shift smoothly.

    Recommended Gear Shifting Speeds 
    Gear Change
    Gear Position
    Vehicle Speed
    Up shift
    1st→2nd
    25 to 40 km/h (15.5 to 24.8 mph)
    2nd→3rd
    45 to 80 km/h (27.9 to 49.7 mph)
    3rd→4th
    60 to 110 km/h (37.2 to 68.3 mph)
    4th→5th
    75 to 140 km/h (46.6 to 86.9 mph)
    Down shift
    2nd→1st
    25 to 35 km/h (15.5 to 21.7 mph)

    HINT:
    1. Leave an interval of more than 2 seconds between gear changes.
    2. If there is a shock when changing gears after the synchronization position calibration, perform the synchronization position calibration again.

← INITIALIZATION (from Nov 2005)PROBLEM SYMPTOMS TABLE (from Nov 2005) →